Vision VISION-64 Guia do Utilizador descarregar pdf (Página 123)

Chapter 4 - The Vision Menus 123

Re-order

This feature will allow you to change the engraving order of your lines in

your layout. It is often used to reduce the amount of cutter up travel or to

minimize the need to change the cutter during the job.

BaseLine Ascending: This will change the order of engraving to work from

the top of the plate to the bottom of the plate.

LineHeight Ascending: This will change the order of engraving to work

from the smallest letter size to the largest letter size.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 186 187

Sem comentários

Vision VISION-64 Guia do Utilizador Página 123