Vision VISION-64 Guia do Utilizador descarregar pdf (Página 14)

14 Vision Software User's Guide

When VISION detects a valid key it switches into registered mode,

identifying itself by placing a serial number in the [F9] EXECUTE screen.

It is the CUSTOMERS RESPONSIBILITY to keep and protect the

SOFTWARE PROTECTION KEY. This may include having insurance for

the key. Keys will normally only be replaced on PROOF OF

DESTRUCTION of the original key otherwise a complete software system

must be purchased.

The SOFTWARE PROTECTION KEY can be plugged into ANY printer

port for normal operation.

NOTE: The printer port must NOT be configured for Bi-Directional for the

Software Protection Key to work properly. If the Key does not work, you

must go into your computers CMOS setup. Each computer is a little

different, but on most computers, you can press the [DEL] key while the

computer is going through the memory test on boot up. Then go to the

section that says something about Peripherals. Then find the section that

says Parallel Port Mode and use the [Page Down] key to change the

selection. Press the [Page Down] key until it says either “Normal” or

“ECP”. These settings work the best. Then press the [Esc] key and then go

to the section that says Save Settings and press [Enter].

IMPORTANT: DO NOT plug a printer or scanner into the Software

Protection key if your printer or scanner has a plug on the back for you to

plug the Software Protection key into. Plug the Software Protection key into

the printer or scanner.

CAUTION: The key will not be detected and may not operate if a printer

or device plugged into the rear is switched off. In situations where this may

cause difficulties, try plugging the printer or device into another printer port

instead of the key.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 186 187

Sem comentários

Vision VISION-64 Guia do Utilizador Página 14