Vision VISION-64 Guia do Utilizador descarregar pdf (Página 59)

Chapter 4 - The Vision Menus 59

Ignore clips: If this is selected, the engraver will try to engrave a job even if

it is off of the plate. If it is not selected, the engraver will ”clip“ or cut off

anything that is outside of the plate.

Note: This command can be used to ensure that items such as

cutout borders are engraved completely when they are extended out to the

edge of your engraving table. Sometimes the software will cut off or clip

parts of your engraving if it is close to the edge of the table and this will

allow you to not have the problem.

Diameter: This will only be highlighted if you are using a rotary machine

such as the Vision Cylindrical Engraver. It is used to enter the diameter of

the object you are engraving.

Write to HPGL plot file: This will send the job to your hard drive instead

of the engraver. This will create a standard HPGL plotter file. You can use

this option if you would like to create a file that you can import into another

program such as CorelDraw. The file will have a .PLT extension.

Driver Select: This will determine which machine the job will be sent to.

By clicking the down arrow to the right of the driver name (Phx.cdf), you

can change to other machine types.

Plate Cut Out: This is used to cut the plate out after you engrave it. By

typing a number in, you can increase the distance between the edge of the

plate and the cut mark.

Spindle Motor Control: This feature is used only with the VE-810

Engraver. It is used to turn the spindle motor on or off while engraving.

You select the type you would like, either Rotary Engrave or Diamond

Drag.

Note: If you click on OK from this screen and get an error message that

looks like the following, please see the Appendix B - Troubleshooting

section of this manual.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 186 187

Sem comentários

Vision VISION-64 Guia do Utilizador Página 59