Vision VISION-64 Guia do Utilizador descarregar pdf (Página 86)

86 Vision Software User's Guide

This feature will change a normal line into an arced line by defining the

margins on your plate.

The only parameters needed to create an easy arc are the margins on the

plate. Enter the top, bottom, left and right margins of your plate and then

select if you want the arc to Bubble Upwards or Bubble Downwards. You

can toggle between the Bubble options by pressing the space bar.

Note: When using the easy arc feature, there is a limitation to what you can

do. For example, when you enter in your margins, the area that you are

allowing the arc to be created in must be at least two times as wide as the

height. If not, Vision will show an error message to that effect. You can not

create a 360 degree arc with easy arc. This must be done using the fixed arc

feature.

If you go into the autoplate feature after you have a line that is arced,

autoplate will erase the arc parameters. You will need to enter the arc

parameters after you are finished using the autoplate feature.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 186 187

Sem comentários

Vision VISION-64 Guia do Utilizador Página 86